Differences

This shows you the differences between two versions of the page.

--- batocera-and-crt-rpi [2024/09/07 10:03] – created atari
+++ batocera-and-crt-rpi [2024/09/27 07:35] (current) – specify the port, add list to HDMI DACs atari
@@ Line 2: / Line 2: @@
 <WRAP center round info>
-This guide only applies to Batocera **v32**. Batocera changed to using the Wayland compositor for most [[:choose_a_single_board_computer|SBC]]s around **v33** (differs depending on exact board), which does not support CRT output on the Pi at all.
+This guide only applies to Batocera **v32**. Batocera changed to using the Wayland compositor for most [[:choose_a_single_board_computer|SBC]]s around **v33** (differs depending on exact board), which does not support output from the composite port at all.
+Using versions **v33** and higher may be possible with active HDMI-to-analogue adapters but this has yet to be confirmed.
 </WRAP>
@@ Line 41: / Line 43: @@
 {{hardware:composite-rca-cable-av-cable-for-xbox-360-e.jpg?240}}
+It may also be possible to use an active HDMI-to-analogue adapter, however this has yet to be confirmed.
+A list of tested DACs by Kuro has been created and adapted by a community member guywith6magikrp to list adapters that have been tested with Batocera. This list is still under construction. https://docs.google.com/spreadsheets/d/15l2xu59ZzRUXuHvtkiI2IGhveLv1gMcB3KOP9EslRaA/edit?gid=0#gid=0
 ===== Preparation =====
@@ Line 77: / Line 83: @@
 </code>
-Then the Raspberry Pi is set up to output to a CRT display via the composite output. Read the [[:batocera_and_crt#editing_the_configuration_files|editing files section]], and then skip forward to the [[:batocera_and_crt#disable_emulationstation_from_forcing_60hz|section about EmulationStation]].
+Then the Raspberry Pi is set up to output to a CRT display via the composite output. Read the [[:batocera-and-crt#editing_the_configuration_files|editing files section]], and then skip forward to the [[:batocera-and-crt#disable_emulationstation_from_forcing_60hz|section about EmulationStation]].
 RPi does not support switchres or standalone MAME. Hence, any configuration that applies to them would not be applicable to RPi. RetroArch does have its own configuration though.
@@ Line 99: / Line 105: @@
 </WRAP>
-If having any issues, refer to the [[:batocera_and_crt|x86_64]] guide as it has more information, however some behavior on that guide only applies to x86_64.
+If having any issues, refer to the [[:batocera-and-crt|x86_64]] guide as it has more information, however some behavior on that guide only applies to x86_64.