Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
supported_hardware [2020/10/17 04:26]
lbrpdx [Nvidia drivers]
supported_hardware [2020/12/14 20:04]
lbrpdx
Line 3: Line 3:
  
 ==== Nano computers / Single-board computers ==== ==== Nano computers / Single-board computers ====
 +Batocera supports multiple single-board computers (SBC):
 +
   * Raspberry Pi Zero   * Raspberry Pi Zero
   * Raspberry Pi (aka 1), including RetroFlag GPi Case   * Raspberry Pi (aka 1), including RetroFlag GPi Case
   * Raspberry Pi 2   * Raspberry Pi 2
-  * Raspberry Pi 3+  * Raspberry Pi 3, as well as CM3
   * Raspberry Pi 4   * Raspberry Pi 4
   * Odroid C2   * Odroid C2
 +  * Odroid C4
   * Odroid XU3, XU4, XU4Q   * Odroid XU3, XU4, XU4Q
-  * Odroid N2+  * Odroid N2 and N2+
   * Odroid Go Advance   * Odroid Go Advance
 +  * RK2020
 +  * Abernic RG351P
   * RockPro64   * RockPro64
   * Asus Tinkerboard   * Asus Tinkerboard
   * MQmaker MiQi   * MQmaker MiQi
   * Amlogic S905 and variants   * Amlogic S905 and variants
 +  * Khadas VIM2
 +  * Khadas VIM3
 +  * Libretech H5
  
 You can download the last stable version for each of these SBCs from [[https://batocera.org/download|the download section of the website]]. You can download the last stable version for each of these SBCs from [[https://batocera.org/download|the download section of the website]].
Line 43: Line 51:
 You can find the list of supported GPU models in https://www.nvidia.com/Download/driverResults.aspx/141847/en-us. You can find the list of supported GPU models in https://www.nvidia.com/Download/driverResults.aspx/141847/en-us.
  
-If you edit the file under Windows, make sure you have an editor that respects Unix line terminators. Don't use Notepad.exe, use a **real** text editor like Notepad++ or Atom, that doesn't replace the Unix line terminations (LF) by DOS/Windows line terminations (CR/LF).+If you edit the file under Windows, make sure you have an editor that respects Unix line terminators. Don't use Wordpad, use a **real** text editor like Notepad++ or Atom, that doesn't replace the Unix line terminations (LF) by DOS/Windows line terminations (CR/LF)
 + 
 +You can connect to [[access_the_batocera_via_ssh|Batocera through SSH]], remount the ''/boot'' partition on write mode [[modify_the_system_while_it_s_running|like explained here]], and edit ''/boot/batocera-boot.conf'' with nano or vi as text editors.
  
 If your card is not supported by the current branch, please check the following forum thread https://forum.batocera.org/d/1851-batoceralinux-525-with-nvidia-legacy-drivers-390xx-discontinued If your card is not supported by the current branch, please check the following forum thread https://forum.batocera.org/d/1851-batoceralinux-525-with-nvidia-legacy-drivers-390xx-discontinued
  • supported_hardware.txt
  • Last modified: 3 months ago
  • by lbrpdx