Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
upgrade_manually [2020/09/17 17:01] – joinski | upgrade_manually [2021/03/27 11:23] – joinski | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ~~NOTOC~~ | + | ====== Manual upgrades/ |
- | ===== Manual upgrades/ | + | |
Upgrades/ | Upgrades/ | ||
* in case you want to reinstall a previous version | * in case you want to reinstall a previous version | ||
Line 7: | Line 6: | ||
To upgrade/ | To upgrade/ | ||
- | - download the file boot.tar.xz of the version you want. The official ones are available here : http:// | + | - download the file boot.tar.xz of the version you want. The official ones are available here : http:// |
- | - a '' | + | - a '' |
Or, starting with batocera.linux 5.23: | Or, starting with batocera.linux 5.23: | ||
- | - [[access_the_batocera_via_ssh|from SSH]], adapt the url to the right architecture and run : '' | + | - [[access_the_batocera_via_ssh|from SSH]], adapt the url to the right architecture and run : '' |
For batocera.linux 5.7 to 5.22: | For batocera.linux 5.7 to 5.22: | ||
- | - [[access_the_batocera_via_ssh|from SSH]], the command line would be: ''/ | + | - [[access_the_batocera_via_ssh|from SSH]], the command line would be: '' |
These commands upgrade -- or potentially downgrade -- the Batocera system. Upgrading or downgrading // | These commands upgrade -- or potentially downgrade -- the Batocera system. Upgrading or downgrading // | ||
- | ==== Error messages when upgrading ==== | + | ===== Error messages when upgrading |
If you get an error message telling you that you don't have enough space on your Batocera system partition when you upgrade, there might be several explanations. | If you get an error message telling you that you don't have enough space on your Batocera system partition when you upgrade, there might be several explanations. | ||
Line 24: | Line 23: | ||
One of them is that you have [[splash_boot|stored several splash boot video files]] on the ''/ | One of them is that you have [[splash_boot|stored several splash boot video files]] on the ''/ | ||
+ | The other explanation: | ||
+ | In this case, you could either delete the " | ||
+ | After that, extract the boot.tar.xz file onto that drive and if successfull, | ||
+ | But be aware, that you would have to do this manual workaround (update-procedure) every time, you want to update to a new version. | ||
- | ==== The batocera.linux usb key ==== | + | So it may be better, to backup all the files from your share-partition (roms, saves, bios, etc.) and start a fresh new install, by flashing the .img.gz file with for example balenaEtcher onto the drive, where you want to have batocera installed, then boot from it and copy back all roms, saves etc. to the share-partition of this new installation of batocera. |
- | {{system: | + | ===== The batocera.linux usb key ===== |
+ | {{system: |
- upgrade_manually.txt
- Last modified: 5 months ago
- by maximumentropy